electrical problem no power after battery install

[bosco]

I just pulled my battery to check the fluid levels and after putting it back in I have no power. I checked all the fuses on both the battery and the motor and its all good. Cables are connected right as I do know the difference between positive and negative. Boat is a bass tracker and the engine is a 4 stroke mercury 90. Checked the fuse panel on the boat as well and all the fuses are intact. Is there some kind of reset button I am not aware of. Kill switch is in the run position. Nothing else I can think of so any help is always appreciated.

 

[Guest]

Is the battery hot? No power on boat and engine? Or just no power on engine?

 

[rodbuilder2]

on most marine batt post they install a reset circuit breaker look real close at the cable end and there may be a small reset button you can reset hope this helps

 

[bosco]

all the accessories have power such as bilge pump etc. No power to engine. Trim doesnt power up either. Nothing at all when i turn the key. Im gonna go back out and check for some kind of reset button.

 

[Buoy-Master]

Check the wire harness at the motor. Make sure its plugged in good.

 

[bosco]

Solved the problem. After taking out the battery and putting it back in i realized I had a loose ground wire.