Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields?

[Creedmoor]

Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields?

I have a G3 CCT 1860 and I have always had some issues with spray coming up from the stern and splashing on my motor.

I recently bought a new fish finder that has a much larger transducer and now the spray is just too much even with the transducer up too high.

I have an idea for a couple of spray shields but need to find a shop that will make them for me.

Need to be either stainless or aluminum and decent thickness.

I have been looking on the internet and have some ideas but was hoping for a recommendation for someone that would take on a small job like this.

Thanks

 

[SHane]

RE: Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields

Try Silvey sheetmetal. They do a lot of small piece work for me.

 

[roll tide]

Re: Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields

PM sent.

 

[Creedmoor]

RE: Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields

SHane - 3/29/2019 9:55 AM

Try Silvey sheetmetal. They do a lot of small piece work for me.

Thanks for the recommendation.

 

[Creedmoor]

Re: Can anybody recommend a sheet metal shop or someone that can fabricate a couple of spray shields

roll tide - 3/29/2019 12:01 PM

PM sent.

Thanks, replied.