question on after market kill switch

[wrechin2]

Then you need to go with option 1 on the ground due to the switch design. Will not work for power interupt. I use the 4 pin on my boats cause I run electric fuel pumps and wire it to kill the engine and fuel pump in case I wreck!!! emoEek And the fat boy goes a flying!!!!! Glad to of helped you. Now I got to go to walter a woods for some pulley for the mill. Late man!!! </p>

</p>

If it is one that is like a factory toggle style you may be able to turn it upside down and use it for power interupt if you want.</p>

</p>

</p>

 

[wrechin2]

Did you get it????

 

[striperchase]

No my little girl would let me get anything done today gonna have to wait till tomo when my wife is home. I took the diagram out and looked at it and should be easy just put connector on the end of the wire and screw in into the brown post on top of the other wire... Right? emoScratch Also is 18 gauge wire ok to use to extend the leads on the kill switch or should I get heavier?

 

[wrechin2]

You got it!!! 18 should be fine. All you are doing is keeping the signal from pulsating making it a solid ground.

 

[jsimages]

where can i order a aftermarket kill switch? i just realized my boat doesnt have one.

 

[wrechin2]

They ususally can be picked up local. Look at post 8 in this thread. there is a link to one.

 

[Bubbakat]

Or go to wally world and getone off the wall for 9.99

 

[striperchase]

I couldn't find one at Walmart. All I could find was replacement lanyards. Here is the one I got and it only took about 4 days to get to my door. http://www.iboats.com/Saf_T_Stop_Sa...56932585--session_id.718894048--view_id.40115

 

[wrechin2]

I know this hole in the wall Small-mart...I mean wal-mart don't carry crap for boats. Have you ever seen a supercenter with only 1 door in the front??? Come to dunlap if you want to see one!!! emoLaugh